Aurorad 1 kg/roll 0.06 0.1 0.2 0.25 0.5 1.0 1.5 mm copper wire magnetic wire enamelled copper winding wire coils - winding wire 1 kg (colour: 1.4 mm, size: red)

1.3mm, 1.4mm, 1.5mm, the diameter of the three specifications of copper wire is relatively thick and there is no winding shaft. If the copper wire of the winding shaft is not easy to straighten 1000g 0.04 0.05 0.06 0.08 0.1 0.15 0.2 0.25 0.31 1.0 1.2mm QA-1-155 EMALLED Copper Wire Magnetic Coil Winding High Temperature 1kg QA-1 corresponds to 2UEW, and its insulation layer is polyurethane, which has good direct weldability of 360~400. Key Features: It has good direct welding performance, can avoid peeling the film during winding and effectively improve work efficiency. The dielectric loss angle tangent is low and has good "Q" valuations under high frequency; No hole in stretch and bend, suitable for high speed winding; It has good features of solvent resistance for solvents and hardeners that generally contain water. Application: In high frequency transformer, inductance coil, relay, motor instrument temperatures commonly used below 155. General Knowledge The diameter indicated in the specification of enamelled wire refers to the diameter of bare copper wire. The diameter of the enamelled wire measured by brake caliper is the outer diameter (including the colour thickness). Uew is the representation of Japanese standards. Both Taiwan and South Koreans are represented by Uew. QA is the representation of national standards and international standards. The difference between them is that the range of Uew outer diameter is relatively loose and the others are basically the same. Note: 2Uew = QA-1 1UEW = QA-2. Q In QA-1 is the serial code, the first Pinyin letter. A is polyurethane paint, the first Pinyin letter Amin. - 1 stands for thin film. (2 for thick film, 3 for thick film) Common Sense: The one in the specification

• It has good direct welding performance, can avoid peeling the film during wrapping and effectively improve work efficiency.
• The dielectric loss angle -Tangente is low and has good "Q" certifications under high frequency;
• No hole in stretching and bending, suitable for high speed winding;
• It has good properties of solvent resistance for solvents and hardeners that generally contain water.