Driver-4/Front-Clamp

Driver-4/front-clamp is designed for lite utility tractor buckets and allows you to work the fire out of our tool and not the other way around. Most convenient mounting of clamp/driver-4 is on bucket corner hand hydraulic side and does help keep operator from doinking their helper. Clamp has 7/8” gap to be placed between bucket scraping edge 5” deep where you will drill ½” hole in your bucket for mounting. We sent washers to shim-up gap between your bucket & clamp. Driver offset/swivel helps each t-post to hang level & swivel allows independent alignment to fencerow. Driver-4 barrel is 80% open to allow twisted beaten up posts in and out of driver barrel. Gripper is mounted on the bottom of barrel along with our t-post puller. No need to put a gorilla grip to each post & unsnap gripper’s just before pressing down that saves on the old wear and tear. Every now and then tilt your bucket or backup slightly when pressing down keeping each post level to stop bowing & kinking. After you planted 6 t-posts you are an expert. Only driver on the market that has ability to be raised up over and up against your old barbwire fencerow then be pressed down. (Extremely harden ground) in worst conditions add a pipe before placing post up into driver. Your local muffler shop could cut a pipe the height of your t-posts above ground minus the length of driver barrel.

• Made in USA
• Only driver designed to aid in parcel replacement of posts against barbwire fence
• Designed to handle used beaten over, smeared, mushroomed & yes new t-posts
• Driver-barrel 80% open at bottom allows t-posts to pass by mounted grippers
• Tilt bucket as you press down posts